Home » Forums » Sixguns.com forums » Gunsmithing and grips

Ruger grips

3 replies [Last post]
Thu, 07/14/2011 - 19:02
slim77
Offline
Joined: 07/11/2011

I would like to buy set of good imitation ivory stear head grips for my new model flat top 44spl.  Any ideas of a supplier that have these fitted fairly close to this new grip frame?

slim

Top
Thu, 07/14/2011 - 19:19
#1
Raven6
Raven6's picture
Offline
Joined: 06/10/2011
I like these grips...

I like these grips... Pricey, but they really look good...
http://www.buffalobrothers.net/grips/ruger_grips.htm

DA's:S&W's - 1917**6" M629-1**4" M629-5**4" M28**6" M28**6" Pre M27**3.5" M57**4" M65**3" M64**4" M681**4" M13-2**4" M10-5**4" Victory**Colt - 4" WWII Commando
SAA's:**1883 4.75" .45 Colt**1885 4.75" .45 Colt**1907 4.75 .38WCF**1921 4.75

Top
Thu, 07/14/2011 - 19:23
#2
Raven6
Raven6's picture
Offline
Joined: 06/10/2011
by the way...

Make sure that you go through all of the pages... There are 4 of them. Make sure you read the Ruger instructions at the end of page 4.

DA's:S&W's - 1917**6" M629-1**4" M629-5**4" M28**6" M28**6" Pre M27**3.5" M57**4" M65**3" M64**4" M681**4" M13-2**4" M10-5**4" Victory**Colt - 4" WWII Commando
SAA's:**1883 4.75" .45 Colt**1885 4.75" .45 Colt**1907 4.75 .38WCF**1921 4.75

Top
Sun, 07/17/2011 - 20:25
#3
slim77
Offline
Joined: 07/11/2011
Thanks for the info, this is

Thanks for the info, this is where I have gotten the set I have on my gun.  The grips are undersized slightly & I sent tracing of factory grips before ordering.  Just wandering if any one else have these grip big enough to fit to my grip frame?

slim

Top